File name pls1__s21.pdf

Multimedia PowerLite® S1, S1+ Service Manual, Section Two: Troubleshooting Disassembly / Assembly Epson PowerLite S1 Series Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the written permission of Epson America, Inc. Copyright © 2005 Epson America, Inc. 3840 Kilroy Airport Way Long Beach, CA 90806-2469 Trademark Information EPSON, Epson PowerLite, and ESC/P are registered trademarks of SEIKO EPSON CORPORATION. Epson Connection is a service mark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective companies. EPSON disclaims any and all rights in those marks. FCC Compliance Statement For American Users This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interface by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/television technician for help. Warning The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this device and may cause interference levels that exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with this device. If this equipment has more than one interface connector, do not leave cables connected to unused interfaces. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. Preface ii Copyright Notice Epson PowerLite S1 Series For Canadian Users This Class B digital apparatus meets all requirements of the Canadian Interface-Causing Equipment Regulations. Cet appareil numйrique de classe B respecte toutes les exigences du Rиglement sur le matйriel brouilleur du Canada. Precautions Precautionary notations throughout the text are categorized relative to personal injury (WARNING), and damage to equipment (CAUTION)